For private clients
Fitted wardrobes and dressing rooms, built by a joiner in Paris
A fitted wardrobe is built to the measurements of your room, not assembled from catalogue carcasses. We draw, build in our 550 m² workshop in Cachan (94) and install dressing rooms, wardrobes and closets in your home, across Paris and the Île-de-France. The same workshop draws it, builds it and fits it.
Discuss your project
Why measurements decide everything in a wardrobe
An off-the-shelf wardrobe comes in a few widths and a single depth. As soon as a wall runs out of square, a skirting board sticks out or a roof slope cuts the height, a gap is left and covered with a filler panel. Built to measure, the carcass follows the wall and the gap disappears. In a Paris flat, where a true right angle is rare, that runs the whole length of the piece.
What we build
The wardrobe takes the shape the room allows. A bedroom takes a closed wardrobe or an open dressing room; a hallway takes a reduced depth with sliding doors; an under-eaves space needs a carcass cut to the pitch of the roof.
- Open dressing rooms, with visible niches and drawers
- Closed wardrobes, hinged or sliding doors
- Mirror doors, which send light back down a narrow hallway
- Corner hanging space and L-shaped returns
- Under-eaves wardrobes, cut to the angle of the slope
- Interior fit-out only, inside an existing built-in cupboard
How the price is decided
We do not publish a price per linear metre, because three metres in melamine and three metres in oak with integrated lighting do not cost the same. Four things make the quote: the run and the height, the material and the finish, the interior fit-out (drawers, hanging rails, lighting, soft-close hardware), and how difficult the installation is. The quote follows a visit and a measurement survey, priced line by line.
From survey to installation
We come and measure on site, then our design office models the wardrobe in 3D. You sign off the volumes, materials and finishes before the workshop starts anything. Fabrication happens in Cachan, the same team installs it, and the workshop stays open to you if you want to see a material before deciding.
Wardrobes installed across the Île-de-France
Designed, built in Cachan and installed in private homes. Photographs of delivered work.
Frequently asked questions
How much does a fitted wardrobe cost?
It depends on the run and the height, the material and the finish, the interior fit-out and how difficult the installation is. A melamine wardrobe and a solid-oak wardrobe with integrated lighting do not cost the same at identical dimensions. We price line by line after a visit and a measurement survey, with no figure quoted at random.
How is this different from a wardrobe retailer?
A retailer assembles carcasses in its catalogue sizes and closes the gaps with filler panels and plinths. We build every carcass to the measurements taken in your home. The difference shows against a wall that is not straight, in a corner and under a slope, which describes most flats.
How long between the quote and the installation?
The lead time depends on the material, the finishes and the workshop's load when the order is placed. We state it with the quote, once the project is settled, rather than give a typical figure that would hold for no actual job.
Can you work in an occupied flat?
Yes. Fabrication happens at the Cachan workshop, which limits the work in your home to the installation itself. We protect floors and circulation routes, and we fit the hours to the building's rules.
Can you fit out an existing cupboard?
Yes. Where the masonry and the doors are sound, we build the interior only: shelves, hanging rails, drawers and dividers, adjusted to the real dimensions of the cupboard.
Do you build wardrobes under a roof slope?
Yes. The carcass is cut to the angle of the slope, and the low zone that a standard unit cannot use is reclaimed as drawers or low hanging space. It is one of the clearest cases for building to measure.
